Install the "F" shaped pull back lever upside down, so the leg of the "F" protrudes up into the disk. One end of the return spring hooks into the middle horizontal bar of the "F" (there is a "V" shaped cutout), the other end hooks into the groove cast into the back edge of the powder measure base.
This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.
Strictly Necessary Cookie should be enabled at all times so that we can save your preferences for cookie settings.
If you disable this cookie, we will not be able to save your preferences. This means that every time you visit this website you will need to enable or disable cookies again.
