Auto Disk Over-travel

Auto Disk Powder Measure Disk Over-travel

When the powder disk over-travels the drop hole in the Auto Disk and Pro Auto Disk powder measures and the powder die is properly set up, check that the drop tube of the powder measure ( thin hollow tube that extends into the powder die) is pressed all the way into the powder measure and seated on the bottom of it’s hole. Occasionally this tube is not seated to the bottom in assembly at the factory. To correct this issue, turn your powder measure upside down and place the drop tube opening against a table edge. Drive the drop tube in using a wooden dowel and hammer or a plastic mallet. CLICK HERE for pictures of this process.